Filter
Top Products
9
Attaching/Detaching the Stand & Wall mounting
Attaching the Stand
100
IMPORTANT— BEFORE DRILLING
ANY HOLES IN THE WALL ENSURE
YOU ARE NOT DRILLING WHERE
THERE COULD BE ANY ELECTRIC
WIRES, WATER OR GAS PIPES
THIS TV REQUIRES A VESA
100 WALL MOUNT, OR EQUIVALENT
To remove the stand
2) Re
1) Remove base as shown opposite
move the four screws highlighted
below
4) The stand will now come off
Wall Mounting the TV.
1) Remove the four screws highlighted
below.
2) The wall mount can now be easily attached
to the mounting holes on
the rear of the
TV.
These holes are indicated in the picture
X23_50 full hd english manual paPage 1 5. 10. 2009 10:26:17
User Guide
Important – If wallmounting this TV, only use the screws already
provided in the wallmounting holes. Using other screws which are
longer could cause irreparable damage to internal parts.
Base of stand
Insert the TV into the stand
Twist the TV into the CLOSE position
until it clicks into place at 45 degrees
1)
2)
3) Remove the two screws in
the neck of the stand.