Filter
Top Products
PAGE 24 — MQ STOW MS20H/MS20E MIXER — PARTS & OPERATION MANUAL — REV. #3 (08/10/06)
MS20H/MS20E MIXER — PRE-INSPECTION
Fuel Check
If your mixer has a gasoline engine, determine if the engine fuel
is low. If fuel is low, remove the fuel filler cap and fill with
unleaded
gasoline. Motor fuels are highly flammable and can be dangerous
if mishandled. DO NOT smoke while refueling. DO NOT attempt
to refuel the trowel if the engine is
hot!
or
running
.
1. Remove the gasoline cap located on top of fuel tank.
2. Visually inspect to see if fuel level is low. If fuel is low, replenish
with unleaded fuel.
Explosive Fuel
NOTE
NEVER!
disable or disconnect the
start/stop switch. It is provided for
operator safety. Injury may result if it is
disable, disconnected or improperly
maintained.
V-belt Check
A worn or damaged V-belt can adversely affect the performance
of the mixer. If a V-belt is defective or worn simply replace the V-
belt as outlined in the maintenance section of this manual.
Blade Check
Check for worn or paddle blades. Make sure that all blades are
adjusted properly. See blade adjustment procedure on page 22.
Replace all defective or damaged blades immediately.
Controls
Start/Stop Switches
This mixer has been equipped with a start/stop switch for both the
gasoline and electric motor mixers. These switches should be
tested every time the engine or motor is started.
Lubricants
Engine Oil
1. Remove the engine oil dipstick from its holder.
2. Determine if the engine oil is low, add correct amount of
engine oil to bring oil level to a normal safe level.
Grease Fittings (Zerk)
1. Check the zerk grease fittings at each end of the mixing
drum. These grease fittings lubricate the dumping
mechanism. If the dumping handle is stiff or hard to move
lubricate these fittings.