Soehnle 7757 Building Set User Manual


 
kg
kg
kg
7
ENGLISH
Cleaning
It is sufficient to clean the scale using a damp cloth and a normal cleaning agent. Do not use any scourers.
Maintenance
The scale does not require any routine maintenance. However, we recommend to check the scale's accuracy at regular intervals.
The regularity of these checks is dependent on the level of use and the state of the scale. If any inaccuracies occur, please
contact your dealer or the Soehnle Professional Service Department.
Note
The display value may be influenced by extreme electrostatic and electro-magnetic interference, e.g. operation of a radio unit
or a mobile phone in close vicinity to the unit. When the electrostatic interference is no longer present, the unit can again be
used for its intended purpose. You may need to switch it on again.
In addition, air currents, vibrations, rapid changes in temperature and direct sunlight may have an effect on the accuracy of
the scale.The scale is protected to IP 54 protection class. Therefore, avoid high levels of humidity, vapours, liquids and strong
contamination. These influences may damage the measuring components and render your warranty claim null and void.
Interference suppression of the unit corresponds to the valid EU directive 89/336/EWG.
Warranty – Liability
If a fault or defect is present on receipt of the unit which is within Soehnle Professional's scope of responsibility, Soehnle
Professional shall be obliged to repair the fault or supply a replacement unit. Replaced parts shall be the property of Soehnle
Professional. Should the fault repairs or replacement delivery not be successful, the statutory provisions shall be valid. The
period of warranty shall be 2 years, beginning on the day of purchase. Please retain your receipt as a proof of purchase.
Should your scale require servicing, please contact your dealer or Soehnle Professional Customer Services.
No responsibility shall be accepted for damage caused through any of the following reasons:
Unsuitable or improper storage or use, incorrect installation or commissioning by the owner or third parties, natural wear,
changes or modifications, incorrect or negligent handling, overuse, chemical, electrochemical or electrical interference or
humidity, unless they can be traced back to Soehnle Professional.
If operating, climatic or any other influences lead to a major change in conditions or material quality, the warranty for perfect
unit functioning shall be rendered null and void. If Soehnle Professional provides an individual warranty, this means that the
unit supplied will be free of faults for the length of the warranty period.
User calibration
If necessary, you can readjust the scale. To do this, you require a calibration
weight of a weight equal to the maximum weight range.
1. Switch the scale on until "0" is displayed.
2. Press both keys (
+ ) for 20 seconds. There must be NO weight
on the scale. "0" is displayed.
3. Press the
key. "CAL 0" appears and then the maximum weight
range of the scale.
4. Place the calibration weight on the scale. This weight must be equal to the
maximum weight range. Press the
key. "CAL XX" appears
(XX = maximum weight range), then "888888" and finally "0".
Then, take the weight from the scale and switch the scale off.
User calibration is always displayed in kg. Press the
key to cancel the operation.