Filter
Top Products
6
ENGLISH
Weighing
Switch the scale on.
The test display "888888" appears. Then "0" appears.
Scale is ready for weighing.
Tare weighing and add-on weighing
Place the container on the base. Press the key. "0" is displayed. Place
the weighing goods on the scale.
Add-on weighing: Press the
key again until "0" is displayed. Add the
additional weighing goods. You can keep doing this up to the maximum load
weight. After the first tare weighing, an "N" (net) appears in the display for
information purposes. "N" is only cleared when you switch the scale off.
Check weighing
Place the reference object on the scale. Tare. Remove the reference object.
Place the object under test on the scale and read off the plus/minus differ-
ence on the display.
Total weight display
When objects are on the scale, press the
key. "0" is displayed. Remove
the goods for weighing. The total weight appears with a minus sign.
Switching off
When the display shows "0", press the
key. When operating the scale
with batteries or rechargeable batteries, the auto-off function is active. When
the display shows "0", the scale switches off automatically after 2 minutes.
Changing units
This is possible at any time. Press the
key to change units. The last unit
used remains active when you switch the scale off and appears again the
next time you switch the unit on.
Fault messages
• Overload: please observe the weight range of the scale (see name-plate).
• Underload: switch the scale on again. If this does not solve the problem,
contact your dealer or service partner.
• With an unclear display (see example on left): switch off the power
supply to the scale for 10 seconds by removing the (rechargeable)
batteries and/or pulling out the power plug.
• (Rechargeable) batteries empty: Please replace or charge them (4 x 1.5 V
AA). Please make sure that you do not try to charge the rechargeable
batteries with the power supply unit plugged in. You require a separate
recharging unit. This is available as an accessory.
Important additional information accu set 2557
Attention: The accu set is only pre-loaded. The scale can be put into
operation immediately. Before the first usage we advice to load the accu
for at least 4 hours in order to achieve the full accu capacity.
If the appliance is operated with the charge adapter, only use
rechargeable batteries. Normal batteries will destroy the appliance.
kg
kg
kg
kg
kg