Filter
Top Products
6
Front Callouts
6 4 3 1
2
5
1. POWER Switch - Use this push button switch to power the MXS2800 amplifier on or
off
2. Channel Level Controls - Two detent controls to precisely adjust the output level of
each channel.
3. PEAK - The PEAK indicator lights whenever the channel is outputting signal at full
strength. For the best signal-to-noise ratio, the right (PEAK) segment should light
occasionally during peak levels; if it lights frequently, you may be overloading the
amplifier and a distorted (“clipped”) signal is probably being output.
4. Audio Indicators - The front panel LED indicators continuously monitor the power
output level for the corresponding channel. For optimum signal-to-noise ratio, set
the level controls so that -6dB is constantly illuminated, with occasional, but not
steady excursions to the red PEAK segment.
5. ACTIVE Indicators - These indicators will illuminate when the power switch is turned
on and the unit is ready to pass audio.
6. PROTECT Indicators - These LED indicators will light when a fault (Short Circuit, DC
Output, Over Current, or Thermal) is detected. The indicators will also light when
the amplifier is first turned on, until the amplifier is ready to pass audio and the
ACTIVE indicators illuminate.