Filter
Top Products
8
Adding Digital Effects (MXP144FX Only)
The MXP144FX features built-in, high quality, 24-bit Multi Effect Processors,
offering 100 studio grade effects presets. The DIGITAL EFFECTS section
features clean Delays, lush Reverbs and multi-effects like Delay + Reverb. The
following details the operation of the internal DSP effects in the DIGITAL
EFFECTS section.
1. Connect a mic or instrument to the desired channel,
adjust the level and equalizer to your liking and make
sure the MAIN MIX fader level is set so you can hear
it in your speakers.
2. Press the effects ON button to activate the digital
effects channel strip.
3. Select the desired effects program using the SELECT
control knob located in the middle of the channel
strip. Rotate the SELECT switch to one of the 100
effects and press to confirm the selection.
4. Rotate the master FX send clockwise and set the
effects to FX fader to the 0 (unity) position.
Note: If sending multiple channels to the internal
effects, and the Digital Effects peak indicator is
flashing red, turn the master FX down.
5. Use the FX control on the input channel to adjust the
level of signal to sent to the effects.
Note: The signal feeding the FX control is sent after
the channel Fader, so the channel Fader has an effect
on that level, meaning the FX level tracks up and
down with the channel Fader.
6. To send the Digital Effects to the monitors, for
example - to add reverb to vocals in the state
monitors, raise the MON control in the Digital Effects
channel strip.