Filter
Top Products
Quantum 614 Series www.quantumrehab.com 27
V. COMFORT ADJUSTMENTS
Controller Position
You can move the controller in toward or out away from the
armrest, or change the position of the controller for either left-
hand or right-hand use.
WARNING! Do not place the controller
cable so that it can be pinched in the seat
frame or the power base frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See figure 16.
3. Slide the controller into or out of the armrest to the de-
sired position.
4. Tighten the setscrew to secure the controller.
To change the controller position:
1. Turn off the power to the controller.
2. Unplug the controller connector(s) from the power base.
3. Cut the wire tie(s) securing the controller cable to the
armrest.
4. Flip up the armrest and loosen the setscrew. See figure 16.
5. Slide the controller out of the armrest.
6. Loosen the setscrew in the other armrest.
7. Place the controller in the other armrest.
8. Tighten the setscrew in each armrest.
9. Use a wire tie to secure the controller cable to the armrest.
10. Plug the controller connector(s) into the power base.
NOTE: If your power chair is equipped with a Synergy
Seat or TRU-Balance 2 Power Positioning System, re-
fer to the controller adjustment information contained
in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several different
heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket.
See figure 17.
2. Loosen the foot platform securement nut one-half turn.
3. Raise or lower the foot platform to the desired height.
4. Reinstall the hardware into the foot platform bracket and
tighten.
5. Tighten the securement nut.
Figure 16. Underside of Armrest
Figure 17. Foot Platform Adjustment
FOOT
PLATFORM
BRACKET
SECUREMENT NUT
SETSCREW
CONTROLLER BRACKET