Filter
Top Products
6
En
1 POWER button (page 8)
Turns this unit’s power on and off.
2 PHONO terminals
Connect to a phono level (MM cartridge) output device. Do not input
line level signals.
To connect a device to the [PHONO] terminals, remove the short-
circuit pin plug inserted in the terminals.
Insert this short-circuit pin plug into the [PHONO] terminals when
nothing is connected to them to cut external noise.
3 CD/LINE terminals
Connect to a DJ player or a line level output component.
4 SIGNAL GND terminal
Connects an analog player’s ground wire here. This helps reduce
noise when the analog player is connected.
5 LINE terminals
Connect to a cassette deck or a line level output component.
6 CONTROL terminal
This is a Ø 3.5 mm mini phone jack type DJ player control terminal.
If you connect a Pioneer DJ player using a control cable (supplied
with a DJ player), you can start playback of control other operations
of the DJ player with the fader of this unit.
7 BOOTH terminals
These are output terminals for a booth monitor.
8 MASTER2 terminals
Connect to a power amplifier, etc.
9 MASTER1 terminals
Connect to a power amplifier, etc.
Be sure to use these as balanced outputs. Be careful not to acci-
dentally insert the power cord of another unit.
a AC IN
Connects to a power outlet using the included power cord. Wait until
all connections between the equipment are completed before con-
necting the power cord.
Be sure to use the included power cord.
b MIC terminal (page 9)
Connects a microphone here.
c USB terminal
Connect the computer.
d PHONES terminal (page 8)
Connect headphones here.
WARNING
The short-circuit pin plugs out of the reach of children and infants. If
accidentally swallowed, contact a doctor immediately.