Filter
Top Products
- Children should be supervised to ensure that they do not play with the appliance.
- The baby monitor has an operating range of 150 meters/450 feet in open air. Depending on the
surroundings and other disturbing factors, the operating range may be smaller (see section
‘Operating range’, in chapter ‘Using the appliance’).
Caution
- Use and store the appliance at a temperature between 10°C and 40°C.
- Do not expose the baby unit and parent unit to extreme cold, heat or direct sunlight.
- Make sure the baby unit and its cord are always out of reach of the baby (at least 1 metre/3
feet away).
- Never place the baby unit inside the baby’s bed or playpen.
- Never cover the parent unit and the baby unit with anything (e.g. a towel or blanket).
- Always place non-rechargeable batteries of the correct type in the baby unit and the parent
unit.
General
- This baby monitor is intended as an aid. It is not a substitute for responsible and proper adult
supervision and should not be used as such.
This Philips AVENT appliance complies with all standards regarding electromagnetic elds (EMF). If
handled properly and according to the instructions in this user manual, the appliance is safe to use
based on scientic evidence available today.
Preparing for use
Baby unit
You can use the baby unit from the mains or on non-rechargeable batteries. Even if you are going to
use the unit from the mains, we advise you to insert the non-rechargeable batteries. This guarantees
automatic back-up in case of mains failure.
Mains operation
1 Put the appliance plug in the baby unit and put the adapter into a wall socket.
The power-on light goes on.
Operation on non-rechargeable batteries
The baby unit runs on four 1.5V R6 AA batteries (not included). We strongly advise you to use
Philips LR6 PowerLife batteries.
Do not use rechargeable batteries, as the baby unit does not have a charging function.
Unplug the baby unit and make sure your hands and the unit are dry when you insert the non-
rechargeable batteries.
1 Remove the lid of the battery compartment with a screw driver (Fig. 2).
2 Insert four non-rechargeable batteries (Fig. 3).
Note: Make sure the + and - poles point in the right direction.
3 Reattach the lid and tighten the screw.
Parent unit
You can use the parent unit from the mains or on non-rechargeable batteries. Even if you are going
to use the unit from the mains, we advise you to insert the non-rechargeable batteries. This
guarantees automatic back-up in case of mains failure.
ENGLISH 7