- Never drop or insert any foreign object into any opening.
- Although the breast pump is compliant with applicable EMC directives,
it may still be susceptible to excessive emissions and/or may interfere
with more sensitive equipment.
- Never use any accessories or parts from other manufacturers or that
Philips AVENT does not specically recommend. If you use such
accessories or parts, your guarantee becomes invalid.
- Clean, rinse and sterilise all pump parts, except the motor unit, the tube
and cap and the adapter before each use.
- Never put the motor unit or the adapter in water or in a steriliser,
as this causes permanent damage to these parts.
- Do not use antibacterial or abrasive cleaning agents when you clean
breast pump parts.
- Do not use the breast pump if the silicone diaphragm appears to be
damaged or broken. See chapter ‘Ordering accessories’ for information
on how to obtain replacement parts.
- Do not continue pumping for more than ve minutes at a time if you
do not succeed in expressing any milk.
- If the pressure generated is uncomfortable or causes pain, switch off the
appliance, break the seal between the breast and the pump body with
your nger and remove the pump from your breast.
Electromagnetic elds (EMF)
This Philips appliance complies with all applicable standards and regulations regarding exposure to
electromagnetic elds.
Preparing for use
The motor unit, the silicone tube and cap and the adapter do not require cleaning and sterilising,
as they do not come into contact with breast milk.
Clean and sterilise all other parts of the breast pump before rst use as described in chapter
‘Cleaning and sterilising’. Also clean these parts after each subsequent use and sterilise them before
each subsequent use.
Assembling the breast pump
Note: Make sure you have cleaned and sterilised the appropriate parts of the breast pump. Wash your
hands thoroughly before you handle the cleaned parts.
Be careful, the cleaned parts may still be hot.
Tip: You may nd it easier to assemble the breast pump while it is wet.
1 Insert the white valve into the pump body from underneath. Push in the valve as far
as possible (Fig. 2).
2 Screwthepumpbodyclockwiseontothebottleuntilitissecurelyxed(Fig.3).
ENGLISH8