Philips SCD465 Baby Monitor User Manual


 
Problem Possible cause Solution
No sound on parent unit. Volume off or too low. Turn VOLUME control (B-9) on
parent unit downwards.
Units out of range. Move parent unit closer to baby
unit.
No connection Units are set to different Set channel selection switches
between units. channels. (A-7, B-10) to the same position
on both units.
Parent unit out of range of Move parent unit closer
tansmitted signal. to baby unit.
Battery pack does Battery life at an end. Replace battery pack (B-13) of
not charge. parent unit.
Interference or poor Mobile or cordless phone(s) Move phone(s) away from
reception. too close to baby monitor. baby monitor.
Interference from other Switch both units to another
baby monitors in the channel using the channel
neighborhood. selection switch (A-7, B-10).
Battery power running low. Recharge battery pack in time.
Transmitted signal is out of Move parent unit closer
range; e.g. there are too many to baby unit.
walls and/or ceilings between
baby unit and parent unit.
Parent unit located too close Move parent unit away
to a window and picking up from window.
interfering signals from other
appliances.
LINK light (B-5) Units are out of range. Move units closer together.
flashing red / LINK
alarm (B-11) beeps. Interference from another Switch to a different channel
baby monitor. (A-7, B-10).
Interference from another Remove other FM source.
FM source.
EN
Troubleshooting
12