Filter
Top Products
6
A CHANNEL B
POWER
SYSTEM CHECK
RANGE
POWER
POWER
Features explanation
Avoiding interference
If there is interference or if sound reception is poor, switch both units to
another channel.
Always make sure that the channel selection switches on both units are set
to the same position.
Monitoring baby silently
Adjust the volume on the Parent unit to the lowest level using the
VOLUME ON/OFF control (do not switch off).
> the sound-level lights visually alert you to baby’s sounds.
The more sound your baby makes, the more lights light.
Checking that the units are in touch
Check that the digital SYSTEM CHECK light on the Parent unit lights
continuously (green) to confirm that the connection between both units
is reliable.
If the light flashes, move the Parent unit closer to the Baby unit.
The light flashes if the units are out of range for more than 30 seconds or
if there is interference. The signal strength icon and the temperature on the
LCD display also flash if the units are out of range for more than 30
seconds or if there is interference.
Switching on the system check alarm
You can switch on the system check alarm on the Parent unit that beeps
when the units are not in touch. The Parent unit is delivered with the
system check alarm switched off.
Open the Parent unit’s battery compartment cover.
Set the switch inside compartment to the ON position ( ).
Close battery compartment cover.
The SYSTEM CHECK light can still flash even if the system check alarm is
switched off.
Switching on the night light
Push the Baby unit night light to switch it on and off.
> Switch off the night light when operating the Baby unit on batteries to
conserve power.
Range 600 ft. in open air
The baby monitor has an operating range of up to 600ft. in ideal open-air
conditions. This means that the units can see each other with no obstacles
in between. Walls, ceilings, large objects and even glass affect the operating
range. The more obstacles there are in between, the shorter the operating
range.
1
2
3
ENGLISH 27ESPAÑOL
Usar pilas
Hacer funcionar la unidad de Bebé sin cordón
Retirar la tapa del compartimiento de pilas.
Insertar cuatro pilas de 1,5V, tipo LR6 (AA) teniendo en cuenta la
indicación de configuración de + y – dentro del compartimiento de pilas.
Pilas no están incluidas; recomendamos las pilas de Alcalina no recargables
de Philips.
Trabar la tapa de nuevo en su lugar y fijarla.
> Si la luz testigo de alimentación se enciende intermitente (roja) instalar
nuevas pilas. La unidad funciona hasta 30 horas con las pilas.
Sustituir el paquete de pilas de la unidad de Padres
Abrir la tapa del compartimiento de pilas de la unidad de Padres.
Desconectar el antiguo paquete de pilas del tomacorriente y retirar
dicho paquete.
Conectar con cuidado el nuevo paquete de pilas al tomacorriente y
colocarlo dentro del compartimiento de pilas.
Cerrar la tapa del compartimiento de pilas.
Desechar las pilas
Desechar pilas usadas de manera respetuosa con el medio ambiente.
No mezclar pilas antiguas con nuevas, o diferentes tipos de pilas.
Retirar las pilas de la unidad de Bebé si el Monitor de Bebé no va a ser
usado durante periodos largos.
1
2
3
1
2
3
4
IFU769bk.p65 13/11/2002, 11:166