Filter
Top Products
4. OPERATION
5
SC360 page 5
OPERATION
(fig. 5)
Transmitter
• Make sure the mains power adapter is
connected correctly.
• Place the transmitter near the baby’s bed,
making sure that the microphone is placed in
the best position for picking up baby’s sounds.
IMPORTANT!
Make sure that the transmitter is always out of
reach of the baby; never place the transmitter
inside baby’s bed or playpen!
• Switch the transmitter on using the POWER
switch
(fig. 1.2)
.
– The red POWER LED lights up.
– If sound is picked up by the built-in
microphone, the transmitter starts
transmitting automatically. The transmission
stops when no sound is picked up any more.
Receiver
• Make sure that batteries are installed
correctly, or a mains adaptor is connected.
• Switch the receiver on to an acceptable sound
level
(fig. 2.4)
.
– The red POWER LED lights up.
– If a sound signal is received from the
transmitter, it is heard via the built-in speaker.
• Adjust the sound level as required.
Note
Do not place transmitter and receiver too close
to each other while operating. Otherwise the
units will start resonating (giving a high-pitch
sound).
IMPORTANT!
Before using the Babysitter, check the sound
transmission to ensure that both units function
correctly. After this first check, sound
transmission should be checked on a regular
basis as follows:
•
Have an adult softly speak into the
transmitter.
–
Sounds transmitted from the baby room
should be heard clearly via the receiver in
another room.
CHANNEL SELECTION
– The Babysitter can use 2 different channels
for radio signal transmission. If sound
reception is very poor, please try the other
transmission channel as follows:
• Move the channel selector on both units to
the other channel
(fig. 1.1 and fig. 2.3)
.
Note: Always make sure the channel switches
on both units are set to the same position.
This ensures optimum reception.
BELT-CLIP
When batteries are installed, the receiver can be
used as a truly cordless product. The unit can be
carried in and around the house, using the easy
belt-clip. This clip can easily be attached to and
removed from the receiver
(fig. 6)
.
English