Filter
Top Products
Screensaver, Sleep mode, Deep Sleep (Power Off) mode is Activated
LightFrame™ goes into the Suspended mode as soon as a screensaver becomes active on your computer.
This is true even though the monitor icon may still have a green center. LightFrameä>> becomes active
again as soon as the screen is reawakened and the screensaver quits.
The same is true when the computer goes into Sleep mode or Deep Sleep (Power Off) mode.LightFrame™
goes into Suspended mode and reawakens when the monitor is reawakened.
Screen or Area is Minimized
LightFrame™ suspends when a highlighted window is minimized. LightFrame™ reactivates when the
highlighted window is again maximized or restored to its previous size.
Another Window or Area Overlaps Highlighted Window or Area
LightFrame™ suspends if a window that is not highlighted overlaps a highlighted window. LightFrame™
reactivates once the highlighted window is again on top.
Miscellaneous
Monitor Turned Off
If the monitor is "hard powered off " while a window or area is highlighted and then hard powered on again,
LightFrame™ is no longer active. The icon may still show the feature as still active. In this case, you have to
exit LightFrame™ and restart it via the icon on the desktop or the Start menu.
If the Monitor is Detached and Another Monitor is Attached
If the monitor is detached from the computer while a highlighted window or area is displayed and then
another monitor is attached, the system will have to be rebooted so that Philips ' LightFrame™ can detect
the monitor 's LightFrame™ capabilities and store the setup information about the new monitor. If the
monitor is not LightFrame™ capable, an Error message appears. See Error Message 2 under the heading
Error Messages. You can abort or continue the set up. However, if you continue, LightFrame™ may not
work with the monitor.
Error Messages
You may see this message when you install LightFrame™.
Error Message 1 dialog box here
LightFrame™ cannot detect a monitor which supports this feature. You can still proceed with the software
installation but LightFrame™ might not run on your system.
You may see this message when you try to switch monitors.
Error Message 2 dialog box here
LightFrame™ cannot detect a monitor which supports this feature. You can still start the software but
LightFrame™ may not work.
RETURN TO TOP OF THE PAGE
Technical Specifications*
109B Product Information
file:///C|/rita wu/gs3LF/ENGLISH/109B/product/product.htm (4 of 7) [10/12/2000 1:55:06 AM]