Filter
Top Products
9
Setting up the massage lounger
1
Where to use the unit
Ensure there is adequate space to recline.
Caution
Do not use the unit in areas with high humidity,
such as the bathroom, because this can lead to
electric shock or other accidents.
Place the unit on a totally flat surface.
Failure to do so may result in the unit tipping over.
•
•
Do not expose the massage lounger to direct sunlight or high
temperatures, such as in front of a heater, etc., as this can cause
discoloration or hardening of the synthetic leather.
Place the unit on a mat to prevent floor damage.
When placing a mat under the unit, the size of the mat should be
sufficient (at least 47 × 28 in. (120 × 70 cm)) to cover the areas
where the unit touches and where the legrest could touch the
floor, as shown in the diagram on the right.
Install the unit near a power outlet.
•
•
•
•
Keep at least 4" (10 cm) away from the wall.
Approx. 77" (195 cm)
Width approx. 33" (84 cm)
Approx. 12" (30 cm)
Approx. 14"
(35 cm)
Mat
Area where legrest
could touch the floor
Area where unit
touches the floor
2
Removing everything from the box and installing the unit
Use care to prevent lower back and other injuries that could occur when lifting this heavy object (approx. 176 bs. (80 kg)).
(The unit must be carried by two persons.)
When using the wheels to move the unit, place a mat on the floor to protect the floor surface.
To put the unit down on the floor
Put the unit down slowly and carefully watch your step.
Put down the legrest by holding it with your hands until it has been set on the floor completely. If you release your hands
before the legrest is fully extended, the legrest will forcefully return to the initial position.
•
•
•
•
Fabric Section
Groove
Hold the clothe
section on the
underside
MatLegrest Back cover
Place your
fingers in the
groove
EP30006US.indb 9 2007/05/11 21:57:45