Filter
Top Products
PAGE 16 — HBC19A/HBC25A REBAR CUTTER • OPERATION AND PARTS MANUAL — REV. #4 (03/30/09)
HBC19A/HBC25A — NAMEPLATE AND DECALS
1
5
HBC19A
OPERATING INSTRUCTIONS
1. Place rebar in rebar holder. Rebar must rest fully
within the blades.
2 Adjust spacing bolt so it holds rebar flush against
stationary cutting block.
3. Tighten spacing bolt and jam nut to hold rebar in place.
4. Place protective cover in the upright position.
5. Press and hold ON/OFF switch to begin cutting
procedure.
6. Continue holding ON/OFF switch until cutting rod
completes cutting cycle.
7. Cutter rod will retract automatically at end of
cutting cycle.
8. Never use worn or damaged blades. Replace as
needed.
9. Periodically inspect oil level and electric motor brushes.
WARNING
2
3
4
MODEL
SERIAL NO.
HBC25A
Keep hands clear while
machine is operating.
WARNING
To prevent injury from flying fragments.
1. Always wear safety goggles and full face
shield.
2. Keep bystanders away from machine
when cutting.
3. Use extreme caution when cutting pieces
8” length or shorter.
4. Steel bar must be fully seated within
cutter blades before cutting.
5. Always adjust and tighten spacing bolt
before cutting.
6. Keep fingers away from cutting edges
during operation.
7. To prevent electrical shock, do not use
cutter when damp.