Filter
Top Products
BA-SERIES WALK-BEHIND TROWEL — OPERATION AND PARTS MANUAL — REV. #6 (07/06/10) — PAGE 19
BA-SERIES TROWEL — ASSEMBLY AND INSTALLATION
Assembly and Installation
Before the trowel can be put into operation there are some
components that must be installed before the trowel can be used.
This section provided general instructions on how to install those
components. Instruction sheet P/N 20485 provides further details
for the handle assembly.
Handle Tube Installation (All Models)
1. Install the
handle tube
to the gearbox as shown in (Figure 5).
The mounting hardware should be contained in the shipping
container.
Figure 5. Handle Tube Installation
CAUTIONCAUTION
CAUTIONCAUTION
CAUTION
The Quick-Pitch™ handle is spring loaded,
personal injury or damage could result from
improper handling or installation. Be careful
when installing this component.
NOTE
Considerable force may be required when
moving the Quick-Pitch™ T-handle
forward or backward.
2. On Quick-Pitch™ models, pivot the
T-handle
back
(full pitch) (Figure 6). This will relax the spring inside the
handle tube. On either model, spread the handle bar ends
just enough to engage the teeth on the handle tube. Attach
the hand wheel assembly, position handlebar to desired
location, and tighten hand wheel firmly.
Figure 6. Handlebar Installation
2. Feed the throttle cable through the cable housing. Make sure
the throttle indicator is on 1".
3. Connect the throttle cable to the engine. (Figure 8),
Honda
and (Figure 9),
Robin
. There should be a piece of wire
installed on the trowel to show where to route the throttle
cable. When connecting the cable housing, make sure that
no more than
1/4" (6.4mm)
of the cable housing protrudes
past the housing clamp on the engine.
Figure 8. Throttle Cable Connection (HONDA)
CABLE HOUSING
ENGINE
THROTTLE
LEVER
SWIVEL STOP
SCREW
THROTTLE
CABLE END
CABLE
HOUSING
CLAMP
Figure 7. Throttle
Throttle Cable Installation (Honda and Robin Engines)
1. Set the
throttle
(Figure 7) to the idle position by rotating
the grip toward the operator and away from the engine.