Mountain Buggy Urban Double-U2204 Stroller User Manual


 
FABRIC CARE AND CLEANING
This outdoor fabric should be cleaned regularly. Brush
off any excessive dirt and rinse with warm water. Fabric
can be removed and washed by hand using a mild
natural
soap solution in luke warm water (no more than
38˚C / 100˚F). Rinse thoroughly to remove soap. DO NOT
use detergents! Allow to air dry. DO NOT tumble dry.
WHEEL ALIGNMENT
It may be necessary to periodically adjust wheel
alignment if stroller steers to one side. The Terrain stroller
has angle struts on the rear axle for this purpose.
1 Loosen all four nuts A, B, C & D holding strut in
position.
2 Slightly tighten outside nut on the opposite side
to the direction it is steering (eg if steering to left
tighten nut D).
3 Test the stroller wheel alignment by pushing it on a
smooth at surface.
4 Re-test the stroller steering after every turn of the
nut until the stroller will run in a straight line.
5 When the correct steering is achieved, turn the
outside nut on the opposite side so it just touches
the side of the tube.
6 Tighten the inside nuts.
HANDLEBAR GRIP
Take care to protect the handlebar grip from abrasion
or sharp objects. Contact your authorised dealer or
distributor for replacement grips and instructions.
A wetsuit glue can be used to repair cuts.
Care and Maintenance
Wrist strap can be used
to hold stroller together
in its fully folded position.
Loop wrist strap around
rear axle then fasten.
Sunhood can be fastened
back by applying velcro on
sunhood window ap to the
velcro on edge of sunhood.
C
B
A
D
8
TYRES/TIRES & TUBES
If a puncture occurs, the inner tube can be repaired with
a bicycle repair kit, or replaced. If the tread becomes
completely worn the tyre/tire should be replaced.
Replacement tyres/tires, inner tubes and repair kits
are available from your authorised dealer or most
cycle stores.
In ating the tyres/tires: In ate to a pressure of 15psi.
(105 KPa) Do not exceed 20psi (140 KPa). The
valves are the same as a bicycle, or car tyre/tire valve.
WARNING: Over inflation may
damage wheel.
STROLLER FRAME
The main frame is aluminium/aluminum and corrosion
resistant. The Urban front assembly and some
components are steel and will corrode if exposed to
environments such as, salt water, salt spray or beach
sand.
If stroller is used in these environments, wash steel parts
in warm soapy water, dry thoroughly and protect by
spraying with light aerosol can oil eg WD40 or CRC.
BRAKE
STORAGE
Store inside in a dry place.
Make sure the stroller is dry before storing.
The brake cam may require
lubrication if it becomes
dif cult to operate.
lubricate this surface
brake lever
wrist strap
velcro
TERRAIN ONLY
WARNING: It may be unsafe to
use replacement parts other than
those supplied or approved by the
manufacturer or distributor.
WARNING: This stroller requires
regular maintenance by the user.