Filter
Top Products
Operation
REFITTING SEAT
✓ CORRECT
ALL MODELS
Note:
Fasten seat onto frame making sure fabric wraps
over and around the top of the side tubes.
7
REMOVING SUNHOOD
Pull support wire out of
sunhood joint, while pushing
against frame.
Note: This operation is child
proof and therefore requires
a degree of force.
Repeat step 1 on other
side.
sunhood
support
wire
3
Unfasten the sunhood
fabric from the stroller
frame and seat near the
handle bar.
1
2
ALL MODELS
REMOVING SEAT
plastic joint
Push seat forward,
then slide fabric up seat
support wire.
Remove seat support
wire from stroller frame
at C and D.
2
2
C
D
seat
support
wire
3
A
B
Unfasten seat from frame along side tubes.
1
ALL MODELS
URBAN
Unfasten strap underneath seat at point A.
Unfasten frame straps at point B.
TERRAIN
X
STORM COVER AND SUN COVER
ACCESSORIES
These accessories fasten at the top, around the side
tubes . They fi t over the sunhood and under the footplate.
The lower elastic loops fasten onto the lug below the
footplate.
lug
lug
strap
WARNING: Do not leave Storm
Cover on stroller in warm conditions.
Check baby’s comfort frequently
when using Storm Cover.
STORM COVER SUN COVER
REFITTING SUNHOOD
Place sunhood in position
and push one side of wire
into plastic joint. Repeat on
other side by pulling wire
away from frame at the
top. Fasten sunhood fabric
to stroller frame and seat,
near handle bar.
Follow removing seat instructions above, in reverse
order.