Mountain Buggy Urban Single-U1204 Stroller User Manual


 
SAFETY HARNESS
Shoulder straps should be
adjusted so they are located
just below or level with a
child’s shoulders. The older
the child, the further up the
seat these straps will go.
ADJUSTING SHOULDER STRAP HEIGHT
A separate safety harness conforming to
British Standard BS6684 may be attached
to the two “D” rings located at the
insertion of the waist harness.
POSITION OF CHILD IN SEAT
Make sure baby
is positioned
down as far as
possible in seat.
6
Operation
1
2
3
insertion
slit
buckle
shoulder
straps
SEAT ANGLE
Seat back can be reclined to any point between upright
and fully reclined position.
ALL MODELS
To adjust: Pull on buckles to
slide straps through buckles
and recline seat. Pull straps
through buckles to raise
seat angle.
Shows upright through to
fully reclined seat angle.
buckles
strap
The Zip Hammock has two
seat back positions. Seat
back is upright when zips
are up, and reclined when
zips are down.
To fasten waist strap
push both buckle
ends A & B into the
crotch buckle C.
Clip shoulder straps
D & E to waist strap
buckles.
2
1
push
B
A
C
D
E
clip
here
Adjust sliding
buckles so the
harness straps are
a rm t.
Move sliding buckles
up as far as possible
to reduce the amount
of strap hanging
loose, eliminating the
risk of chocking.
3
sliding
buckles
4
sliding
buckles
To release, press
sides of centre
buckle.
5
WRONG
CORRECT
X
X
SEAT ANGLE
TERRAIN ZIP HAMMOCK OPTION
REMOVING
INSERTING
With a hand inside the back of
the seat rotate the rectangular
shaped buckle and push short
side through the insertion
slot, while pulling strap at
the front.
Re-thread short side of buckle
through the most suitable insertion
slot for your child. Once buckle is
through, turn so it is at against
seat back, and check it is secure
by pulling on strap.
To locate buckle when adjusting
straps, slip your hand up the
inside back of the seat (or
inside the pocket on the Zip
Hammock model).
strap
short side
buckle
NOTE: The stroller would become unstable if a child was
to move up the seat. For this reason the seat retains a
slight angle to prevent the stroller from tipping back.