Filter
Top Products
6
Preparation
You will need to have all components on the parts list
shown to t Carrycot to your stroller.
Have a look at sides of Carrycot. There are three holes
on each side of Carrycot to allow snap locks to be tted.
Con guration varies depending on the Mountain Buggy
model you have.
• Two snap locks are tted to each side of Carrycot.
The unused hole can be tted with the spare screw
and cover button.
How to t the Snap Locks
1. Place one snap lock over hole A. Make sure it is
aligned correctly with the hole in Carrycot.
2. Using Allen key, rotate screw in snap lock in
clockwise direction until screw is tight. Snap lock
will still be able to rotate but is rmly attached.
3. Connect second snap lock according to model
directions below.
4. Repeat on other side.
For Urban (Jungle) models
5. Fit second snap lock to position B.
6. Fit small screw and cover button to hole C.
For Terrain Models
5. Fit second snap lock to position C.
6. Fit small screw and cover button to hole B.
Confi guration 1 Instructions
A
PLEASE FOLLOW THESE INSTRUCTIONS IF YOU
ARE FITTING:
a: a Single Carrycot to a Single Stroller
b: a Twin Carrycot to a Double Stroller
Fitting the Snap Locks to the Carrycot
A
B
C
URBAN
TERRAIN
C
B
A
›››
2 x screws
2 x cover buttons
Allen key
Carrycot
PARTS LIST
4 x snap locks