Filter
Top Products
Place child restraint
rear-facing in the
back seat. With
child restraint in the
fully reclined
position, make sure
level line on side of
shell is level with
ground. Adjust
child restraint if needed.
NOTE: Hook top anchorage strap to recline
foot (see “Adjusting the Top Anchorage
Strap” section).
5
Fasten one LATCH
belt connector to
the anchor in the
vehicle seat located
in the vehicle seat
bight. Repeat for
other side of child
restraint. See your
vehicle owner’s
manual for more
information.
4
7
Push down firmly
on the child
restraint and pull
up on the loop to
tighten belt.
With weakest
hand at belt path,
tilt and push the
child restraint
forward and
back, and from
side to side. If the
LATCH belts do
not loosen, your
child restraint
should be secure.
NOTE: Some “play” from front to back or
about an inch from side to side is
acceptable.
If the child restraint does not remain tight,
do not use the child restraint in this
seating location with this LATCH system.
After checking for
hot seat and
buckles, place
child in child
restraint. See
“Securing Your
Child in the Child
Restraint” section.
8
9
WARNING
!
LATCH hooks MUST be securely
fastened. Failure to do this can result
in serious injury or death.
10
To Release LATCH:
Remove LATCH
from vehicle
anchors by
pressing the red
release button on
each connector.
Rear Facing Use: 5-35 lbs. (2.3-16 kg), 19-36” (48-91 cm)
30 31
6
NOTE: Make sure
arrows on
connectors are
facing up.
4358-4274 US Priori 5/25/07 8:33 AM Page 33