Filter
Top Products
GB
English
12
3. PLACING YOUR BABY IN THE MAXI-COSI CABRIOFIX
• Loosen the shoulder belts by pressing the quick adjuster button (1,1) and pulling the shoulder belts
towards you (1,2).
• Release the belt buckle and drape the belts with the tongue sections over the hooks (2) and pull the
buckle forward, attach the loop of the belt pad over the edge of the quick adjuster button (3).
• Make sure there are no toys or other hard objects in the shell.
• Position your baby comfortably in the Maxi-Cosi CabrioFix.
• Join the buckle tongue sections together and insert them into the buckle (until it clicks) (4).
• Pull the shoulder belts tight using the quick adjuster belt strap on the front. The loop can be secured
under the shell rim (5).
A. Adjusting the height of the shoulder belts
The shoulder belts should run through the slots located directly above the baby’s shoulders.
• Open the door of the storage compartment (6).
• Pull the shoulder belts through the slots in the shell and cover.
• Place the shoulder belts back, at the required height and use the same slots in both the shell and the cover.
• Check to make sure the belts can be used properly and that they are not twisted.
IMPORTANT!
• The more tightly the belts are fastened around the child, the better the protection. You should be able to
fit no more than one finger between the belts and your child.
• The belts should never be twisted or damaged.
• When positioning the baby make sure that he/she does not sit on the belts by hanging them to the side
behind the belt hooks. Hook the belt pad of the belt that goes between the legs behind the edge of the
quick adjuster.
• If you are unable to fasten the harness belts properly or pull them tightly, contact your supplier
immediately. Do not use the Maxi-Cosi CabrioFix under any circumstances!
B. Removable seat insert
The Maxi-Cosi CabrioFix has a removable seat insert (7) to creat a flater lying position for newborn babies
and support the head in a sideways direction. When the baby is (approx 4 or 5 months) remove the filling
block (8) to make the seat deeper, then you can still use the head support.
87
6
5
4
32
1
0109_GBA_cabriofix_I_BW 20-01-2006 13:13 Pagina 12