Filter
Top Products
3. Install your precut wire shelf pilasters to the top half of your cabinet above the tray slide pilaster. Note: when
installing your wire shelf pilaster above the tray slide pilaster on the 2-door, the top of the pilaster closest to the drain
tube must be cut off to an overall length of 17.625” for clearance. The thumbscrews should be used to lock the shelf
pilasters in place at the top of the cabinet.
4. (Use steps 4 and 5, when installing on top half.) Install your precut wire shelf pilasters to the bottom half of the
cabinet first.
5. Install your tray slide pilasters using the bottom slotted holes on the pilaster, as shown in Fig. 4. Press in and down
to lock into place. Use the thumbscrews to lock into place.
6. When installing a full cabinet door of tray slides, always start with the bottom and work up, making sure the top and
bottom pilasters are flush where they meet.
7. Hang tray slides on tray slide pilaster with tap openings facing down (see Fig. 1). Insert shelf clips at desired levels.
There should be no less than a minimum of 9” between the top wire rack or tray slide and evaporator drain pan.
NOTE: The 2-door kit is K00334. When installing this kit, the notched pilaster goes around the drain tube on the top
back wall. The foam tape should be installed between the tray slide pilaster (on the pilaster) and the back wall of the
cabinet (see Fig. 2).
8010553
Sheet 2 of 2
Rev. 04/01/99
Mounting Stud
Cabinet
Fig. 1
Tray Slide
Tray Slide Pilaster
Foam Tape
Drain
Tube
Mounting Stud
Bottom Half
Mounting Stud
Top Half
Inside Set of
Slots are used
for Left/Right
Front Corner
Location
Fig. 2
Fig. 3
Bottom Half
Fig. 4
Top Half