Filter
Top Products
DL806 and DL1608 Owner’s Manual
8
The iPad Air and iPad Air 2 also do not t the included iPad tray. Again, though; we’ve got you covered.
As mentioned two pages ago, an iPad Air may be docked to a DL Series mixer with a Lightning
connector, but it requires an Air tray insert (sold separately).
Here’s how to install the iPad Air tray:
(1) remove the four screws from the mixer, as seen in the illustration on the previous page.
(2) If applicable, slide the tray insert out from the mixer and SAVE IT SOMEWHERE SAFE! Should you decide
to dock an iPad 2, iPad (3rd generation), or iPad (4th generation) to the mixer, the tray will be necessary.
(3) slide the iPad Air tray right to left, making sure to line up the sides and the screw holes (Figure A below).
(4) put the screws back into the mixer from where you just removed them to hold the iPad Air tray insert
into place (Figure B below).
(5) for the complete iPad Air tray kit installation instructions, click here!
iPad Air tray kit
Figure A
Figure B