LG Electronics 26LT670H Model Vehicle User Manual


 
12
206-4213
Automated Installation Routine Wizard (Cont.)
Pro:Centric Manual Conguration
If you already know the required Data Channel and Pro:Centric
Application Mode settings for the TV, you may streamline the
setup process by entering this data manually.
1. Use the Up/Down arrow keys on the Installer Remote to
select/highlight Pro:Centric Manual from the Automated
Installation Routine Wizard Welcome screen. Then, press
OK.
2. The rst Manual Conguration Screen (see example at right)
enables you to specify the following data:
• Pro:Centric Mode: Use the Left/Right arrow keys to select
the appropriate Pro:Centric Application Mode (GEM,
FLASH, or Conguration Only).
• Channel Number: Either directly enter or use the Left/Right
arrow keys to select the Data Channel.
Note: For remote management only, select the Pro:Centric
Mode “Conguration Only” option to search for TV E-Z
Installation (splash screen, configuration, or firmware) data
downloads. Pro:Centric application data will not be down-
loaded.
Note: Select the “Back” button from the Manual Conguration
screen or press the key on the Installer Remote, if desired,
to return to the Welcome screen.
3. Once you have specied the data as indicated above, you
have two options:
• To save the data entered and exit the wizard, use the
arrow keys to select Save and Exit, and then press OK.
The Pro:Centric application and/or E-Z Installation data will
be downloaded to the TV at a later time. This option is use-
ful, in particular, if the Pro:Centric server is not yet set up.
• To initiate a real-time download of Pro:Centric application
and/or E-Z Installation data, use the arrow keys to select
Next, and then press OK.
Note: Signal must be detected on the Data Channel from
the Pro:Centric server in order for you to select “Next” (you
should see a “Data Channel found” message below the
signal strength indicator).
The Pro:Centric Manual Conguration will proceed with
the remaining Pro:Centric application and/or E-Z Installa-
tion data download steps, as shown on the second Manual
Conguration screen (see example at right). When the
Pro:Centric Manual Conguration is complete, the wizard
exits, and the TV will turn OFF.
Manual Configuration
Pro:Centric Mode
Channel Number
Signal Strength
0%
GEM
1
< >
BACK
NEXT
Save and Exit
OK
Move
Prev.
Manual Configuration
Processing Pro:Centric Configuration.
Step 4 may take up to 5 min(s).
Please wait...
Step 1 Detecting the type of Pro:Centric network
Step 2 Locating the Pro:Centric Server
Step 3 Determining the Pro:Centric mode
Step 4 Downloading the application files
Step 5 Downloading the maintenance files
Step 6 Saving the Pro:Centric confiugration
Warning - Do not remove AC power or the signal cables during these steps
50%
RF
DIGITAL 75
GEM
In Progress
:
:
:
:
:
:
Prev.