Filter
Top Products
© Learning Resources, Inc., Vernon Hills, IL(U.S.A.)
Learning Resources Ltd.,King’s Lynn, Norfolk (U.K.)
Please retain ouraddress for future reference.
Made in China. LRM3774-GUD
Fabriqué en Chine. Informations à conserver.
Made in China. Bitte bewahren Sieunsere
Adresse für spätere
Nachfragen auf.
Hecho en China. Conservar estos datos.
Visit our website to write a product review
or to find a store near you.
Battery Information
Installing or Replacing Batteries
WARNING! To avoid battery leakage, please follow these instructions carefully. Failure to
follow these instructions can result in battery acid leakage that may cause burns,
personal injury, and property damage.
Requires: 2 x 1.5V AAA batteries and a Phillips screwdriver
• Batteries should be installed or replaced by an adult.
• Answer Buzzers require (2) two AAA batteries each.
• The battery compartment is located on the bottom of the unit.
• Toinstall battery,first undo the screw with aPhillips screwdriver and remove the
battery-compartment door. Install batteries as indicated inside the compartment.
• Replace compartment door and secure with screw.
Battery Care and Maintenance Tips
• Use (2) two AAA batteries.
• Be sure to insert batteries correctly (with adult supervision) and always follow
the toy and battery manufacturer’s instructions.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium)
batteries.
• Do not mix new and used batteries.
• Insert batteries with the correct polarity. Positive (+) and negative (-) ends must be
inserted in the correct directions as indicated inside the battery compartment.
• Do not recharge non-rechargeable batteries.
• Only charge rechargeable batteries under adult supervision.
• Remove rechargeable batteries from the toy before charging.
• Only use batteries of the same or equivalent type.
• Do not short-circuit the supply terminals.
• Always remove weak or dead batteries from the product.
• Remove batteries if product will be stored for an extended period of time.
• Store at room temperature.
• To clean, wipe the surface of the unit with a dry cloth.
• Please retain these instructions for future reference.
Information to User
NOTE: Thisequipment has been tested andfound to comply within the limits for aClass B digital device, pursuant to Part
15 of theFCC Rules. These limitsare designed to provide reasonable protection against harmful interference ina
residential installation.
This equipment generates,uses, and can radiate radio frequency energy and if notinstalled and used in accordancewith
the instructions, maycause harmful interference to radio communications. However,there is no guarantee thatinterference
will not occurin a particular installation. If this equipment does cause harmfulinterference to radio or television reception,
which can bedetermined by turning the equipment off and on, theuser is encouraged to tryto correct the interference by
one or moreof the following measures:
-Reorient or relocatethe receiving antenna.
-Increase the separationbetween the equipment and receiver.
-Connect the equipmentinto an outlet on a circuit different from thatto which the receiver isconnected.
-Consult the dealeror experienced radio/TV technician for help.
NOTE: Changes ormodifications not expressly approved by the party for compliance couldvoid the user’s authority to
operate the equipment.