4
5
6
4
How to Assemble Your Stroller
To Open Stroller
Remove any cardboard inserts or plastic
ties used to protect the product during
shipment.
Release the locking latch.
Unfold, making sure both side locks snap
into place.
2
3
2
1
To Assemble Rear Wheels
Remove and discard protective plastic
sleeve from ends of rear axle assembly.
Position rear brake assembly as shown,
with brake levers pointing towards
stroller handle.
Push both brake assemblies onto rear
leg tubes at the same time until spring
loaded buttons click into place.
Lay stroller on its side. Slide wheel onto
axle.
Push down on wheel until you hear a
click. Pull up on wheel to make sure it is
properly secured. If wheel pulls off, push
wheel onto axle again but push metal
clip in at the same time. Make sure
wheel is secure. Failure to secure wheels
may result in injury to your child.
Repeat for second side.
TO REMOVE WHEEL. Press metal clip in
and pull wheel off.
NOTE: Keep wheels at a recommended
tire pressure of 35 p.s.i. (241 kPa) (select
models).
2
3
1
2
3
4
5