Filter
Top Products
6
How to handle the swing
■ Make sure that usage does not commence until the apparatus has been properly assem-
bled and subsequently controlled by an adult.
■ Instruct children on the proper handling of the apparatus and advise them of possible dangers.
■ Remember that the children's natural play instinct and temper may lead to unforeseeable
situations excluding a responsibility of the manufacturers.
■ Although dangers to children during proper use of the apparatus are highly unlikely, all
play on the apparatus should be monitored by an adult.
■ For cleaning and caring the swing only use environmentally friendly and no aggressive or
corroding agents.
■ Regularly grease the moving parts with some drops of oil.
Instructions for Assembly
■ Ensure that you have received all the parts required (see check list) and that they are un-
damaged. Should you have any cause for complaint, please contact your KETTLER dealer.
■ Before assembling the equipment, study the drawings carefully and carry out the operati-
ons in the order shown by the diagrams. The correct sequence is given in capital letters.
■ The fastening material required for each assembly step is shown in the diagram inset. Use
the fastening material exactly as instructed. The required tools are supplied with the equip-
ment.
■ The equipment must be assembled with due care by an adult person. If in doubt call upon
the help of a second person, if possible technically talented.
■ Please note that there is always a danger of injury when working with tools or doing ma-
nual work. Therefore please be careful when assembling this machine.
■ Ensure that your working area is free of possible sources of danger, for example don’t lea-
ve any tools lying around. Always dispose packaging material in such a way that it may not
cause any danger. There is always a risk of suffocation if children play with plastic bags!
■ Bolt all the parts together loosely at first, and check that they have been assembled cor-
rectly. Tighten the locknuts by hand until resistance is felt, then use spanner to finally tigh-
ten nuts completely against resistance (locking device). Then check that all screw connec-
tions have been tightened firmly. Attention: once locknuts have been unscrewed they no
longer function correctly (the locking device is destroyed), and must be replaced.
■ For technical reasons, we reserve the right to carry out preliminary assembly work (e.g.
addition of tubing plugs).
■ Waste Disposal: KETTLER products are recyclable. At the end of its useful life please dis-
pose of this article correctly and safely (local refuse sites).
Assembly Instructions
GB