Filter
Top Products
10
P9723pr-0920
Plate
• While holding the handlebar in place, carefully turn the
vehicle over.
• Again, make sure the end of the steering column is through
the hole in the steering linkage.
• Fit the steering column cap onto the end of the steering column.
• Insert a #8 x
3
/4" screw through the large opening in the steering
column cap and into the hole in the steering column. Tighten
the screw.
8
9
• Slide the plate under the steering column, as shown.
• Insert a #8 x
3
/4" screw into the plate and tighten.
6
7
• Lift the front end of the vehicle up slightly. Check to be sure
the steering column fits through the hole in the steering
linkage. Lower the front end of the vehicle.
BOTTOM VIEW
Steering Column
Connector
Steering Column Cap
Steering Column
BACK VIEW
• Turn the vehicle upright.
• Fit the handlebar steering column down through the large
opening in the front end of the vehicle.