Filter
Top Products
Groove 2 Instruction Manual Page 5
Installing and Operating the Canopy Set
Once the canopy set is installed, you can operate each canopy independently.
• With the stroller open, clip BOTH sides and the center of the canopy set onto
the handle tubes just above the retaining blocks, taking care not to catch any
material underneath the clips. See Figure 5. Attach the hook and loop tabs at
the top of the canopy to the handle tubes.
• Place the rear aprons behind the seat backs and attach the female snap on the
bottom of each apron to the male snap on the top of each seat back.
• The canopy and visor can be adjusted into several positions ranging from fully
closed to fully extended, or any position in between.
• To open the canopy, pull forward on the front edge of the canopy until the canopy
is fully extended. Once the canopy is extended, push down on BOTH side hinges
to lock it in the open position. See Figure 6.
• The visor can be opened (or closed) by pulling (or pushing) it from under the canopy.
• NOTE that the top rear portion of the canopy has a roll back window. To open, pull the
forward edge up, roll the ap back, and secure using the elastic loop attachments.
• To close the canopy, unlock both side hinges and push the front edge of the
canopy toward the rear of the stroller. See Figure 7.
• To remove the canopy set, unsnap the snap on the top of each seat back.
Unfasten the hook and loop tabs from the handle tubes. Pull the clips on the
canopy away from the handle tubes. See Figure 8.
!
WARNING
Possible pinching hazard - Be careful when closing and
opening the side hinges.
Figure 7 Figure 8
Figure 5
Figure 6