Filter
Top Products
Overbed Table 2 Part No 008187
3 Assembling the Overbed Table
1. Position the column assembly on the base.
2. Assemble the column assembly to the base with the two locknuts provided and tighten securely.
3. Using extreme caution, push down on the outer column and remove the packing pin from the
column assembly as shown in Detail “A”.
4. Allow the column assembly to expand slowly.
5. Position the table top on the column assembly and tighten securely with the six Phillips
®
screws
provided.
FIGURE 1 Assembling the Overbed Table
4 Using the Overbed Table
1. Lift up on the handle on the side of the overbed table and adjust the overbed table to the desired
height.
2. When the table is at the desired height, release the handle.
ƽ
ACCESSORIES WARNING
Invacare products are specifically designed and manufactured for use in conjunction with Invacare
accessories. Accessories designed by other manufacturers have not been tested by Invacare and
are not recommended for use with Invacare products.
ƽ
WARNING
ALWAYS wear safety glasses and use extreme caution when removing the packing pin from the
column assembly of the overbed table. The column assembly is spring loaded and will extend
suddenly when the packing pin is removed. Serious injury or damage can occur.
After any adjustments, repair or service and before use, make sure that all attaching component
parts are secure.
For this procedure, refer to FIGURE 1.
For this procedure, refer to FIGURE 2.
Phillips Screws
Locknuts
Column
Assembly
Push Down with
this Hand
Packing Pin
Table Top
Top View of
Column Assembly
Base
DETAIL “A”