Filter
Top Products
To recline seat:
To fully recline, unhook buckle on back of the seat
(Figure I).
To place seat in upright position, push seat forward
and reconnect buckle located on back of seat.
Extra webbing can be placed in the rear pouch so
it does not hang down and drag.
To adjust the recline position, adjust the buckle on
the strap.
WARNING: Child may slip into leg openings
and strangle. Never use in a reclined car-
riage position unless the T-shield and
shoulder straps have been readjusted to
the new seat position.
Step 9. Using the infant car seat
adapter bar
When the car seat adapter bar is properly installed
onto “The Everyday Stroller,” it is designed to be
used with the following infant car seat brands and
models. Graco
®
Snug Rider,
®
Century
®
Avanta,
®
Evenflo
®
On My Way.
®
The trade names and trademarks of Graco,
®
Century,
®
and Evenflo
®
are the trademarks of their
respective companies.
WARNING: Failure to follow these warnings
and assembly instructions could result in
serious injury or death.
The front child tray must be removed
before using the infant car seat
adapter bar.
Lift up the textile cover of the seat’s side tubes.
Insert adapter bar with buttons on the inside. Push
in the spring buttons while pushing adapter bar into
the seat’s side tubes end (Figure J1). Release but-
ton and continue pushing in the bar until the spring
buttons lock into the holes located on the inside of
the seat’s side tubes. Pull on bar to make sure it is
locked in place.
To remove adapter bar push in spring buttons
with your finger or pen and pull out the bar. Store
adapter bar in the under seat basket when not in
use (Figure J2).
6
I
J1
J2
Rear Recline
Strap
Car Seat
Adapter Bar
Black
Spacers
Adapter Bar
Textile
Cover
Spring Lock
Buttons
Under Seat
Basket