InStep SB100 Stroller User Manual


 
5
To convert stroller to
a frame carrier
WARNING:
Please request the help of
another adult to help you put
the frame carrier on.
1. With rear wheels locked, release the
Frame carrier waist strap cover located
between the front legs (Picture M).
2. Push the lever up on the front wheels to
lock them from swiveling. Tilt the stroller
back slightly, and slide the booties onto the
front wheels. This will prevent your clothes
being soiled by the wheels (Picture M).
3. Release the waist buckle and sternum
(chest) buckle (Picture N).
4. To close the stroller, step behind the
stroller, then push the handle buttons
located on the sides of the stroller frame.
5. With the help of another adult to steady
the child in the seat, stand in front of the
stroller. Place one arm through the shoul-
der strap and lift stroller onto your shoul-
der/back. You will find this much easier if
the other adult also assists you with hold-
ing the other shoulder strap and guiding it
over your other shoulder.
6. Once both shoulder straps are on, pull
down on the shoulder strap ends to tight-
en. This will position the child higher onto
your shoulders (Picture O).
7. Adjust the height of the sternum straps by
sliding them up or down. Buckle the
sternum strap then pull the end of the
sternum strap to tighten (Picture P).
8. Buckle the waist strap and pull end of the
waist strap to tighten (Picture Q).
M
Waist Strap Cover
Swivel
Lock
Lever
Front
Wheel
Booties
N
O
Sternum
Strap
Buckle
Waist Buckle
Shoulder
Straps
Sternum Stap
Adjusts Up or
Down
Waist
Belt
Buckle
Shoulder Strap
End
P
Q
Sternum
Buckle
Waist
Buckle
Waist Strap
Sternum
Strap
Adjusing
Slide