Filter
Top Products
Step 5. Installing Parent’s
Convenience Tray
Snap the parent tray onto the handle bar aligning the tray’s
holes with the handlebar’s knobs
(Figure E).
Step 6. Installing optional Child Tray
(sold separately)
Align the child tray onto the frame just below side latches,
Step 7. Installing optional Child booty cover (sold separately)
Undo the shoulder and waist straps from the stroller seat center buckle. Place the booty into the seat and insert
the shoulder, waist and crotch straps through the slits in the booty, snap the sides onto the bottom of the frame.
Place child into booty and adjust the restraint straps to a snug fit. Zipper close (Figure F1,F2).
Fig. E
Handle Knob
Parent Tray
Hole
Fig. F1
Fig. F2
Step 8. Adjusting the angle of the canopy and using the zipout weather-
shield.
Unsnap the canopy sides from the frame loosen the hook loop tab from center of console, rotate canopy to the
desired angle to help block the sun. Note the zipout weathershield should be zippered in when rotating the
canopy forward (FigureG1)
Unzip the canopy edge to expose the weathershield. Align the hook and loop of the inside flap so it does not
hang down in your child’s face. Loop the 2 hooks together under the front fender. When not in use roll up
weather shield into zippered area to store (Figure G2).
Fig. G1 Fig. G2
Canopy Tab
Canopy
Snaps