Filter
Top Products
SKU 90975 Page 3
Unpacking
When unpacking, check to make sure the following parts (shown on page 5)
are included. If any parts are missing or broken, please call Harbor Freight Tools at
the number on the cover of this manual.
Assembly
1. Locate both Bases (2). Place each Elbow (3) over each Base (2), line up the
bolt holes, and fix in place using the 4 sets of Elbow Nuts and Bolts (5).
See Figure A.
Figure A
2. Select a surface that will not scratch the finish of the frame. Place both Elbows
(3) on each side of the Center Joining Tube (4) so that the horizontal ends are
on the inside. See
Figure A.
3. Insert the Center Joining Tube (4) over the lower part of one Elbow (3) as far as
it will go. Line up the Center Joining Tube Bolt (6) with the notch on the Elbow
and tighten partially. Repeat on the other side. Tighten both Center Joining
Tube Bolts securely. (Check for tightness periodically).
See Figure A.
4. Attach Square End Caps (7) onto both ends of each Base (2).
See Figure D.
5. Insert the Risers (1) over the upper part of the Elbows. Be sure the notches for
hanging the Hammock (9) are facing inwards.
See Figure B.
The Risers (1)
should rest on the Ring Stopper on the Elbow ( 3).
See Figure C.
Center Joining
Tube (4)
Riser (1)
Center Joining
Tube Bolt (6)
Base (2)
Elbow (3)
Elbow Nut
and Bolt (5)
6. Replacement parts and accessories. When servicing, use only identical
replacement parts. Use of any other parts will void the warranty. Only use
accessories intended for use with this tool. Approved accessories are available
from Harbor Freight Tools.
7. Do not use or assemble under the influence of alcohol or drugs.