Filter
Top Products
SKU 45342 Page 3
Warning: The warnings, cautions, and instructions discussed in this instruc-
tion manual cannot cover all possible conditions and situations that may oc-
cur. It must be understood by the operator that common sense and caution
are factors which cannot be built into this product, but must be supplied by
the operator.
Unpacking
When unpacking, check to make sure all parts listed on Page 4 are included. If
any parts are missing or broken, please call Harbor Freight Tools at the number
on the cover of this manual.
Assembly
You will need a hammer and a crescent wrench to assemble this product.
1. Insert top of Lifting Pole [D] into the Hub [C] that has already been attached
to the Seat Cushion [A].
2. Now insert Seat Cushion and Lifting Pole assembly into the top of the Tool
Tray [E].
3. Check and tighten all fasteners as needed.
Operation/Maintenance
With its convenient tool tray, comfortable padded seat, and non-marking wheels,
the Pneumatic Roller Seat is essential for the multi-tasking craftperson.
To lower seat, sit on the Stool and pull up on the handle until you have lowered
the seat to the desired height (See Diagram I on Page 4). To raise seat, stand
next to the Stool and pull up on the handle. Release handle when seat has risen
to the desired height.
Do not let children play on or around the Roller Seat.
Do not stand on Roller Seat or use the tool tray to carry large amounts of weight.
Do not attempt to exceed the Roller Seat’s 300 lb capacity.
Once assembled, do not attempt to take this product apart.
Do not expose to heat. Parts of this product are under pressure.
REV 08/03