Filter
Top Products
T26413/T26414/T26415 (Mfd. 9/13+)
-3-
Mounting
Because of the dynamic forces involved in operat-
ing the arbor press, we strongly recommend that
you mount it to a benchtop or other stable working
surface to prevent it from moving during operation
and causing accidental injury or damage.
The base of the arbor press has
3
⁄8" mounting
holes on each side of the upright (see Figure 3).
The strongest mounting option is a "Through
Mount" (see example below) where holes are
drilled all the way through the workbench—and
hex bolts, washers, and hex nuts are used to
secure the machine in place.
Figure 3. Mounting hole (1 of 2).
3
⁄8" Mounting Hole
(1 of 2)
Figure 4. Example of a "Through Mount" setup.
Machine Base
Workbench
Hex
Bolt
Flat Washer
Flat Washer
Lock Washer
Hex Nut
Figure 5. Example of a "Direct Mount" setup.
Machine Base
Workbench
Lag Screw
Flat Washer
Another option is a "Direct Mount" (see example
below) where the machine is secured directly to
the workbench with lag screws and washers.
Assembly
1. Remove cap at one end of sliding handle
assembly (see Figure 6).
Figure 6. Handle cap removed.
Cap
Cap
Screw
Handle