Filter
Top Products
TROUBLESHOOTING18
My stroller seems to pull and lean to one side.
Be sure each tire is fully infl ated. We recommend that you initially use
compressed air to fi ll the tires and then just use your pump for quick
refi lls. You can go to your local gas station to pump your tires just as
you would for a bike. If your stroller is leaning to one side, please
make sure the axle is completely inserted and “snapped” into each
side of the stroller frame.
The brake-bar on the Urban Advantage stroller seems tight. Is
this normal?
Yes, the kickstand comes down and is locked into place when you
step on the brake-bar. This takes some additional force. It is normal
and will take less force after some use. There is an adjusting-screw on
the cable near the brake-bar. Turning the adjusting-screw clockwise
reduces the amount of force required to extend the kickstand. Adjust
the screw for the least amount of tension that still allows the kickstand
legs to remain in the vertical position.
Should the kickstand touch the ground?
No. The kickstand should be about ½ inch above the ground when
assembled correctly. This leaves room for tire defl ation or varying
weight of children.
My child is very tall for his age, and the top fl ap bothers him. Can
we remove it?
The fl ap is a safety precaution for use with infants when the seatback
in the horizontal position. You can simply fold over the fl ap when
the seatback is in the upper positions. If you are sure the stroller will
not be used with an infant, you can remove it entirely with scissors.
However, be sure you remove only the fl ap and do not cut the threads
below.
I cannot lock my stroller in the collapsed position.
If the hook is at all bent out, it does not stay securely connected
and will pop open. Our suggestion is to push the hook in toward the
stroller a little (it is not diffi cult to bend the metal). The best way to do
that would be to swivel the hook so it is away from the frame and then
push it in.
Troubleshooting