Filter
Top Products
9
785-7-00
10 11 12
To Adjust Back
Step 1.
Pull up on the wire behind the
seat to fully recline it.
Step 2.
After seat is fully reclined, lift
seat upwards until it locks into
one of the other positions.
Fabric caught
in the latches may prevent
them from locking. When
returning seat to upright
position, do not allow fabric
to be pinched in the latch.
To Adjust Canopy
Push or pull canopy to desired
position.
To Change to Swivel
or Non-swivel Wheels
Front swivel wheels lock for use on uneven surfaces such
as grass, stones or gravel.
Before locking swivels, first push stroller forward a few
feet to ensure that the wheels are correctly positioned.
Slide DOWN for swivel. Slide UP for non-swivel.
To Use Child’s Tray
Always secure your child with the
seat belt. The child’s tray is not a restraint device.
DO NOT lift the stroller by
the child’s tray.
Use care when clamping the
child’s tray on the stroller
with a child in the stroller.
Snap the child’s tray under the
fold latch on both leg tubes as
shown.
To Fold Stroller
Step 1.
Before folding stroller, fold
canopy and recline seat. Apply
brakes to prevent stroller from
moving.
Step 2.
1. Slide red button on handle to the right.
2. Twist grip away from yourself until it stops.
3. Push stroller handle down.
OR
Pull latches up to release
and fold handle down.
Step 3.
Close and lock storage latch.
To Adjust Leg Rest
Push in the buttons at both
sides of the leg rest. While
holding buttons in, move leg
rest up or down to desired
position.
To avoid burns, never put hot liquids in
the parent’s tray. To prevent tipping over, do not place
more than 3 lbs. (1.4 kg) on the parent’s tray.
Step 1.
Remove the two screws found on top of the stroller handle
tubing just above the canopy. Do not remove canopy
screws.
Step 2.
Fold the tray on its “hinge”
several times to break in
the hinge.
Step 3.
Snap parent’s tray to stroller
handle as shown. Reinsert
screws, attaching tray to handle.
To Use Parent’s Tray
Hinge
To Attach the Graco
®
Safety Seat (on certain models)
Improper use of this stroller with a
carrier may result in serious injury or death.
Do not use this stroller with a safety seat that is not
the Graco
®
brand.
Read the owner’s manual provided with your
Graco
®
safety seat before using the seat with this
stroller.
If you do not have the owner’s manual for the
Graco
®
safety seat, call Graco at 1-888-224-6549.
Make sure the stroller is fully assembled according to
the preceding instructions.
Step 1.
If the stroller is folded, unfold it and RECLINE the
stroller seat back to its lowest position.
Step 2.
Push down on the tray to be sure it is securely attached
to the stroller.
Step 3.
If your child is already in the safety seat because you
have been using it as a carrier, make sure child is
secured with the harness.
Always secure your child with the
safety seat harness when using the safety seat in
the stroller.
Step 4.
Move the carrier handle
into the carrying position.
Step 5.
Position the carrier so that
the mounting notches fit over
the edge of the arm bar or
tray. Push down on carrier
until the attachment latch
snaps into the arm bar or
tray.
See following page...
Ë
Ê
Ë
Ì