Graco PD220686A Car Seat User Manual


  Open as PDF
of 96
 
REAR-FACING INSTALLATION WITH LATCH
12
1
7
6
5
4
3
2
LATCH belt must be routed through opening in
child restraint for
rear-facing mode.
(see page 29, fig. d
Belt must lay flat and not be twisted.
Adjust child restraint to recline position
(see fig. a and page 25, fig. a0LACE
rear-facingONVEHICLESEATEQUIPPEDWITH
LATCH anchors.
&OREASEOFINSTALLATIONEXTEND
LATCH belt to its
MAXIMUMLENGTH
(OOKCONNECTORSTOVEHICLELOWERANCHORS
(fig. b). Pull connectors to be sure they are
securely attached to the anchor points. (fig. c).
Press down firmly in center of child restraint
while pulling
LATCH adjustment belt. (fig. d).
0ULLFRONTTOBACKANDLEFTTORIGHTATBELTPATH
TOCHECKFORSECUREINSTALLATION(fig. e)4HE
CHILDRESTRAINTSHOULDNOTMOVESIDETOSIDEOR
FORWARDMORETHANINCHCM
#HECKTHATTHELOWERANCHORAGEBELTSTAYS
tight and does not slip from the tightened
position. If it does not stay tight, try another
SEATINGPOSITIONORCONTACT#USTOMER3ERVICE
#HECKLEVELINDICATORONCHILDRESTRAINT
Vehicle mustBEONLEVELGROUND and child in
CHILDRESTRAINTWHENCHECKINGLEVELINDICATOR
Ball MUST be entirely in blue zone (fig.f). If
necessary, place rolled towels under child
RESTRAINTATVEHICLESEATCREASEUNTILENTIREBALL
ISINBLUEZONE4HENRECHECKLEVELINDICATOR
(see pages 24-25, fig. c
DO NOT use tether
rear-facing4ETHERmust
BESTOREDSEEh4ETHER3TORAGEvPAGE
0ERFORMTHISTESTEVERYTIMEYOUDRIVEWITHYOUR
child.
 previous next