Filter
Top Products
8
5
Tap leg tips on the floor to be sure
they are completely on.
Golpee la punta de las patas sobre
el piso para asegurarse que han
entrado completamente.
Frappez les extrémités des pieds sur
le plancher pour vous assurer qu’ils
sont complètement enfoncés.
37
Text and viewing hole
Texto y agujero para mirar
Inscription et trou voyant
4
Use viewing hole to line
up the end of the screw
with the hole in the tube.
Tighten the screw securely.
Repeat for the other feet.
CHECK that feet are secure
by wiggling the feet.
Use el agujero para mirar
para alinear el extremo del
tornillo con el agujero en
el tubo. Ajuste el tornillo
apretadamente. Repita
para las otras patas.
VERIFIQUE que las patas
están aseguradas moviendo
las patas.
Utilisez le trou voyant pour
aligner l’extrémité de la vis
avec le trou dans le tube.
Serrez la vis solidement.
Répétez pour les autres
pieds.
VÉRIFIEZ que les pieds de
base sont bien installés en
les tortillant.
Problem Solving
SWING WON’T OPERATE:
1. No batteries in swing.
2. Batteries dead.
3. Speed setting too low.
4. Batteries in backwards — check “+” and “-”.
5. Corrosion on battery terminals. Rotate batteries in place against
terminals, or clean with sandpaper or steel wool if corrosion is
severe.
6. Baby leaning too far forward.
7. Baby grabbing swing legs. (Discontinue use.)
8. Seat not pushed high enough for a good start.
9. Protective device activated. (Turn off motor, wait 3 minutes, then
restart swing.)
SEAT DOESN’T SWING VERY HIGH:
1. Control setting too low.
2. Blanket hanging down, causing increased wind resistance.
3. Batteries too weak.
4. Baby leaning too far forward.
5. Baby too heavy or too active. (Discontinue use.)
6. Soft carpet (swings higher on hard floors).