Filter
Top Products
1. For ease of installation, extend
UAS to its maximum length
and remove from storage bars.
2. Position base in vehicle seat as shown.
3. Make sure UAS is through
vehicle/UAS belt path normally
used for vehicle seat belt.
➋
.
Belt must lay flat and not be twisted.
4. Hook Connectors to vehicle lower
anchors. Pull firmly on Connectors to
be sure they are attached ➌.
5. Tighten UAS by pushing down
hard on base and pulling the
adjustment belt ➍.
6. NEVER put two UAS connectors
on one vehicle UAS anchor unless
specifically allowed by the vehicle
manufacturer
➎
.
7. Test infant restraint for secure
installation as described in infant
restraint “Final Safety Check” page.40.
8. Check that the UAS stays tight
and does not slip from the tightened
position. If it does not stay tight, try another
seating position or contact Elfe at 1-800-667-8184.
37
7.3 Using UAS (Universal Anchorage System) to install Base
➋
➍
➎
➌