Graco 9745 Crib User Manual


 
5
361-10-99
67
HINTS:
!
If top rails do not unlatch, lift
!
the center of the floor higher.
!
Both tubes must be released
!
for the top rail to fold.
Step 4.
Pull center up all the way.
To fold the top rail:
!
Lift up slightly on the top rail.
!
Push up on the button located under
!
the symbol to release the two tubes.
!
Push down.
Step 5.
Gather your unit together.
Do not force.
If unit will not fold, look for a
partially latched top rail. Squeeze
the latch button to release the rail.
Step 6.
Find the bottom corner belt loop
(only one). This loop is for holding
unit and mattress together while
carrying.
Step 7.
Wrap the mattress around your unit.
Fasten together the VELCRO
®
straps,
attaching the bottom strap to the
bottom corner belt loop.
To Fold Your Pack N Play
®
Step 1.
Lower the back flap. Apply
locks on wheels or casters,
if present. Release the two
VELCRO
®
straps under the
Pack N Play, and remove the
mattress.
Step 2.
IMPORTANT:
Raise center halfway
BEFORE unlocking
rails.
Grasp the red handle
on the center of the floor
as shown.
Push down and turn
handle. Then pull up
approximately halfway
to the top rails.
To Cover Your Pack N Play
®
Models with changing table and wheels:
Pull the cover over your unit
as shown, making sure carry
handle attached to Pack N
Play mattress is lined up with
zipper.
Before pulling bag up, insert
folded changing table into the
side opposite the handle as
shown. Pull bag up to cover
end. Zip together.
Models with wheels only:
Turn unit upside down, so that
wheels point up. Pull the cover
over your unit. Make sure carry
handle attached to Pack N
Play mattress is lined up with
zipper.
Push the plastic end of the bag
over wheels and feet. Turn unit
over and pull bag up to cover
end. Zip together.
Models with feet or
casters and feet:
Pull cover over your
unit. Be sure carry
handle attached to
Pack N Play mattress
is lined up with zipper.
Turn unit over. Pull bag
up to cover end. Zip
together.
On certain models:
The cargo bag opens on either end. Slip the bag over
the Pack N Play. Check that the carrying handle
attached to the Pack N Play mattress sticks out the
hole in the bag. Zip both ends.
Handle
Wheel
Foot
Handle
To Use as a
Playard/Portable Crib
Place mattress into your unit
with padded side up.
Always use your unit with
mattress installed soft side up.
Slide the two
VELCRO
®
straps
through slots in bottom of Pack
N Play and fasten to VELCRO
®
on underside. This will prevent
mattress from moving.
Your Pack N Play is ready to
use.
8
At first your Pack N Play may be like a new pair of
shoes. You may need to break it in by slightly stretching
the netting and fabric. If the center does not stay down,
place some weight (several books) in the center of the
unit and let it stand overnight.
Step 3.
The top rail has a center piece
with two tubes hidden under the
fabric. The button on the bottom
of the center piece releases the
two tubes when it is pushed up.
Center
piece
Tube
Push UP button
under fabric
CARE AND MAINTENANCE
FROM TIME TO TIME CHECK YOUR PACK N
PLAY for worn parts, torn material or stitching.
Replace or repair the parts as needed. Use only
Graco
®
replacement parts.
IF PACK N PLAY IS USED AT THE BEACH, you
MUST clean sand off your Pack N Play, including
the feet, before packing it into cover. Sand in top
rail lock may damage it.
TO CLEAN PACK N PLAY, use only household
soap or detergent and warm water.
TO WASH CARRY BAG AND FITTED SHEET,
machine wash in lukewarm water on delicate
cycle and drip-dry. NO BLEACH.