Filter
Top Products
5
359-4-98
6 87
Step 5.
Do not use your Pack N Play
without the mattress provided
by Graco.
Cover soft side of mattress with
fitted sheet (on certain models).
Place mattress into your unit
with padded side up.
Always use your unit with mat-
tress installed soft side up.
Slide the two VELCRO
®
straps
through slots in bottom of Pack
N Play and fasten to VELCRO
®
on underside. This will prevent
mattress from moving.
Make sure the mattress is
installed properly before placing
your child in the Pack N Play.
Your Pack N Play is ready to
use.
Accessory Features
(on certain models)
SIDE FLAPS:
You can raise side and end
flaps if desired.
Unfasten VELCRO
®
strips at
bottom of flap. Roll flap up.
Fasten in place with snap loops
at top.
TOY BAG:
Toy bag snaps on at top of end
without flap. Maximum weight 2
lbs (0.9 kg).
DO NOT machine wash or dry
in a dryer. DO NOT dry clean.
Spot clean with a damp cloth
and a mild detergent. NO
BLEACH.
MESH NET:
Mesh net can be fitted to the top
of the Pack N Play if desired.
CARGO BAG:
The cargo bag can be snapped
on to the end of the Pack N
Play for easy access. Unzip
both ends and tuck inside the
bag. Maximum weight 5 lbs
(2.3 kg).
CASTERS:
To apply the locks, push DOWN
on the levers.
To release the locks, lift UP on
the levers.
WHEELS:
To apply the locks, push DOWN
on the levers.
To release the locks, lift UP on
the levers.
Step 1.
Lower any roll-down flaps. Apply
locks on wheels or casters.
Release the two VELCRO
®
straps
under the Pack N Play and
remove the mattress.
Step 2.
IMPORTANT:
Raise center halfway
BEFORE unlocking
rails.
Grasp center loop
as shown and pull up
approximately halfway
to the top rails.
To Fold Your Pack N Play
®
HINTS:
!
If top rails do not unlatch,
!
lift the center of the floor
!
higher.
!
Both tubes must be
!
released for the top rail
!
to fold.
Step 4.
Pull center up all the way.
Step 5.
Gather your unit together.
Do not force.
If unit will not fold, look for
a partially latched top rail.
Squeeze the latch button to
release the rail.
To fold the top rail:
!
Lift up slightly on the top rail.
!
Push up on the button located under the symbol
!
to release the two tubes.
!
Push down.
Step 3.
The top rail has a center piece
with two tubes hidden under the
fabric. The button on the bottom
of the center piece releases the
two tubes when it is pushed up.
Center
piece
Tube
Push UP button
under fabric
Step 6.
Find the bottom corner belt
loop (only one). This loop is for
holding unit and mattress
together while carrying.
Step 7.
Wrap the mattress around
your unit. Fasten together
the VELCRO
®
straps, attaching
the bottom strap to the bottom
corner belt loop.
Step 1.
Pull cover over your unit.
Be sure the carrying handle
attached to the mattress is
exposed.
Step 2.
On models with wheels, push
the plastic end of bag over the
wheels and feet of the unit.
Step 3.
Zip together.
The cargo bag (on certain
models) opens on either end.
Slip the bag over the Pack N
Play. Check that the carrying
handle attached to the mat-
tress sticks out the hole in the
bag. Zip both ends.
To Cover Your Pack N Play
®
Handle
Wheel
Foot
At first your Pack N Play may be like a new pair of
shoes. You may need to break it in by slightly stretching
the netting and fabric. If the center does not stay down,
place some weight (several books) in the center of the
unit and let it stand overnight.