Filter
Top Products
5
768-3-98
Step 2.
Be sure frame is latched as
shown before continuing
assembly.
Step 1.
Snap swivel lock button onto
wheel mount as shown. This
must be done BEFORE pin is
inserted (next step).
Step 2.
Insert pin through hole in wheel
mount. Then push round end of
a front wheel assembly up onto
pin as shown until it snaps into
place.
NOTE: Check wheel attachment
by pulling down on the front
wheel assembly.
Step 3.
Repeat above steps for the
other side.
Step 1.
Turn stroller over as shown.
Step 2.
Unsnap the basket flap from the
rear brace, and slide rear axle
through the hole in one axle
bracket.
Continue to push the rear axle
into the hole of the other axle
bracket.
Step 3.
Snap the basket flap around
both the rear axle and the rear
brace.
HINT: This may be easier if
stroller is partially folded. See
To Fold Stroller instructions.
8
To Unfold Stroller
Step 1.
Release storage latch (on inside
of handle on right side of stroller).
Step 2.
Unfold stroller as shown.
Be certain the stroller is fully erected
and latched before allowing your child near the stroller.
67
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Open stroller on carton
as shown until latched.
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
Pin (2)
Rear axle
Front wheel
assembly (2)
Flattened
carton
Rear
canopy
Front canopy
(only on
some models)
Retainer
(2, 1 extra)
Rear wheel (2)
Cap
(2, 1 extra)
Rear hubcap (2,
only on some models)
To Assemble Front Wheels
Latch
To Assemble Rear Wheels
Spokes
toward
inside
Rear
axle
Retainer (red)
Wide end toward wheel
Hubcap (only on
certain models)
Snap red retainer into
axle groove. Then snap
cap over red retainer
as shown. Be sure cap
is snapped securely
over red retainer. Snap
the hubcap (only on
some models) on last.
Step 4.
Place one rear wheel, red retainer, cap, and hubcap (only
on certain models) on one end of rear axle in order as
shown below. Push red retainer onto axle BEFORE
attaching white cap. Repeat on other side.
To Use Brakes
Always apply
both brakes to park stroller.
Push DOWN to park.
Lift UP to stroll.
Wheel
Cap (white)
Attach AFTER
retainer is on axle
Swivel lock
button (2)
Frame
Arm bar
Step 1.
Push ends of bar into open-
ings at front of stroller, until
the bar locks in place.
Pull on bar to be sure both
sides are attached.
NOTE: It is normal to be
able to wiggle bar slightly.
Step 2.
Snap fabric flap onto the bar.
To Assemble Arm Bar
To Change to Swivel
or Non-swivel Wheels
Front swivel wheels lock for use on uneven surfaces
such as grass, stones or gravel.
NOTE: Before locking swivels, first push stroller
forward a few feet to ensure that the wheels are
correctly positioned.
Push buttons up or down, depending on model, to
lock or release swivels. Turn swivel to check that it
is locked or released.
Insert pin
Push
wheels up
Round
end
To Raise Footrests
Lift footrest and hook wire into
footrest bracket.