Graco 7225 Stroller User Manual


 
5
780-8-98
To Unpack Stroller
Step 1.
Flatten stroller carton to
protect floor.
Step 2.
Open stroller on carton
as shown until latched.
Step 1.
Turn stroller over as pictured
above.
Step 2.
Position rear axle assembly
as shown.
Step 3.
Start both wheel mounts onto
leg tubes at the same time.
Step 4.
Push both wheel mounts all the
way on until they snap onto the
legs.
Step 5.
Pull firmly on both wheel mounts
to be sure they are securely
attached.
6 8
To Unfold Stroller
Step 1.
Unfold footrest from under
armrest.
Step 2.
Release latch.
Step 3.
Unfold as shown.
Be certain
the stroller is fully erected
and latched before allowing
your child near the stroller.
Step 1.
Line up pin on bottom of front
leg with a wheel assembly as
shown. Plastic snap inside
wheel mount must be away
from pin.
Step 2.
Push wheel assembly onto pin
until it snaps in place.
Step 3.
Repeat for other wheel assembly.
NOTE: Pull firmly on each wheel
assembly to be sure the wheel
assemblies are securely
attached.
To Install Basket
Step 1.
Position the basket under rear of
stroller so the straps are toward
front of stroller.
Step 2.
Fasten the 8 snaps as shown.
7
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing, call Customer Service
at 1-800-345-4109.
THIS PRODUCT REQUIRES ADULT ASSEMBLY.
No tools required for assembly.
Retainer (2,
1 extra)
Rear axle
assembly
Frame
Rear wheel (2)
Cap (2,
1 extra)
Slung
basket
Flattened
carton
Latch
To Assemble Rear Axle To Assemble Front Wheels
Snaps
Snaps
To Assemble Rear Wheels
Place parts on both ends of rear axle in order as shown.
Push red retainer onto axle BEFORE attaching white cap.
Be sure cap is snapped securely over red retainer.
Retainer (red)
Wide end toward wheel
Wheel
Cap (white)
Attach AFTER
retainer is on axle
Spokes
toward
inside
Rear
axle
Snap red retainer
into axle groove.
Then snap cap
over red retainer
as shown.
Front wheel
assembly (2)
Brake levers
point UP
Strap
Strap
To Adjust Back
Step 1.
Push back of seat slightly
forward while squeezing as
shown to unlock.
Step 2.
Adjust to desired position.
Do not pull
on this bar!
Plastic
snap