Filter
Top Products
9
760-11-99
10 11 12
To Secure Your Child
Avoid serious injury from falling or
sliding out. Always use seat belt.
Your stroller may have a single button buckle, double button
buckle, or two-buckle seat belt. Follow the appropriate
instructions below.
Double Button Buckle Seat Belt:
Place crotch strap between
childs legs. Snap both side
buckles to the center buckle.
Adjust belt as needed to get
a snug fit around your child.
Push in on front of buckle to
release.
Two-Buckle Seat Belt:
Place crotch strap between
childs legs. Snap together the
buckles on each side of crotch
strap. Adjust belt at each buckle
as needed to get a snug fit
around your child.
Squeeze both sides of each
buckle to release.
To Adjust Back
Step 1.
Push in the two latches behind
the seat to recline it.
Step 2.
To return seat to upright
position, lift the seat back until
both latches are locked.
Fabric caught
in the latches may prevent
them from locking. When
returning seat to upright
position, do not allow fabric
to be pinched in the latches.
To Use Brakes
Push DOWN FIRMLY to park.
Check to make sure brake is on
by trying to push the stroller.
Lift UP to stroll.
To Unfold Stroller
Step 1.
Release storage latch located
by the stroller handle and
begin opening stroller.
Step 2.
Continue unfolding until both
latches lock.
Storage
latch
Always apply
brakes when parking stroller.
To Adjust Canopy
Push or pull canopy to desired
position.
Snap the childs tray under
the fold latch on both leg
tubes as shown.
Always secure your child with
the seat belt. The childs tray is not a restraint
device.
DO NOT lift the stroller by the childs tray.
Only use safety seat if your model has a childs tray
designed for use with a safety seat.
Use care when snapping the childs tray on the
stroller with a child in the stroller.
To Fold Stroller
Before folding the stroller:
1. Fold the canopy.
2. Lock the front swivels
(on certain models).
Step 1.
Fully recline the seat back.
Step 2.
Pull latches up to release
and fold handle down.
OR
On other models:
1. Slide red button on handle
to the right.
2. Twist grip away from
yourself until it stops.
3. Push stroller handle down.
Step 3.
Close completely and fasten
the storage latch to the handle.
To Use Childs Tray*
The following optional features
are found only on certain models:
Single Button Buckle Seat Belt:
Place crotch strap between
childs legs. Snap both side
buckles to the center buckle.
Adjust belt as needed to get a
snug fit around your child.
Push in on front of buckle to
release.
Ë
Ê
Ë
Ì
To avoid
burns, never put hot
liquids on the parents
tray. To prevent tipping
over, do not place more
than 3 lbs. (1.4 kg) on the
parents tray.
Snap parents tray to stroller handle as shown.
To Use Parents Tray
(one of two styles)*
*
On certain models
OR
For trays with an adapter:
Step 1.
Push the screw through the
hole on the handle of the
stroller and line up the
adapter as shown.
Step 2.
Screw the adapter halfway
on and then snap the
adapter to the stroller
handle. Finish tightening
the screw.
Step 3.
Snap one pin on the parent
tray into the hole in the
stroller handle as shown.
Repeat on other side. Rest
the tray on the adapters.