Filter
Top Products
5
762-3-00
6 87
PARTS LIST
CHECK that you have all the parts listed below
BEFORE assembling your stroller.
If any parts are missing,
call Customer Service at 1-800-345-4109
or visit our Internet website, www.gracobaby.com.
THIS PRODUCT REQUIRES ADULT ASSEMBLY
.
No tools required for assembly.
Retainer
(2, 1 extra)
Rear axle
Frame
Rear wheel (2)
Cap
(2, 1 extra)
Front wheel
assembly (2)
Rear axle
mount (2)
Arm bar (2)
(on certain models)
Right
Left
Step 1.
Flatten stroller carton to
protect floor.
Step 2.
Release storage latch.
To Unpack Stroller
Flattened
carton
Storage
latch
To prevent serious injury or death
from choking, remove and IMMEDIATELY discard
the plastic covers on the front leg pins.
Locking
latch
Step 3.
Open stroller on carton until
locking latches on both sides
are locked.
Step 1.
Line up pin on bottom of front
leg with the wheel assembly as
shown. Plastic snap inside
wheel mount must be away
from pin.
Step 2.
Push wheel assembly onto pin
until it snaps in place.
Step 3.
Repeat for other wheel.
Pull firmly on each wheel assembly to be sure
the wheel assemblies are securely attached.
Plastic
snap
To Assemble Rear Axle
Step 1.
Turn stroller over and position
rear axle mounts on rear legs
as shown. Brake levers must
face rear of stroller. Push axle
mounts on until plastic tabs
snap into the slots on the legs.
Step 2.
CHECK that axle mounts are
securely attached by pulling
firmly on each axle mount.
Step 3.
Put the axle through both axle
mounts and the center support
as shown.
Brakes face
rear of stroller
To Assemble Rear Wheels
Place parts on rear axle in order as shown. Push red
retainer onto axle BEFORE attaching white cap.
Be sure cap is snapped securely over red retainer.
Retainer (red)
Wide end toward wheel
Wheel
Cap (white)
Attach AFTER
retainer is on axle
Spokes
toward
inside
Rear
axle
Snap red retainer
into axle groove.
Then snap cap
over red retainer
as shown.
To Unfold Stroller
Step 1.
Release storage latch and
begin opening stroller.
Step 2.
Continue unfolding until both
latches lock.
To Use Brakes
Always apply
both brakes when parking
stroller.
Push DOWN to park.
Lift UP to stroll.
Step 1.
Place crotch strap between
childs legs and snap both side
buckles to the center buckle.
Adjust belt as needed to get a
snug fit around your child.
Step 2.
Push in on front of buckle to
release.
Step 1.
Place crotch strap between legs
and fasten both belt
buckles together. Adjust belt at
both buckles as needed to get a
snug fit around your child.
Step 2.
Squeeze sides of buckles to
release.
To Secure Your Child
Avoid serious injury from falling or
sliding out. Always use seat belt.
Your stroller will have either a three-point buckle or a
double buckle waist belt. Follow the appropriate instructions
below.
Three-Point Buckle Waist Belt:
Double Buckle Waist Belt:
To Adjust Canopy
Push or pull canopy to desired
position.
To Assemble Front Wheels
To prevent serious injury or death from
choking, remove and IMMEDIATELY discard the plastic
covers on the ends of the rear axle.
Plastic cover
Zip tie