Graco 44339 Car Seat User Manual


 
10
FORWARD-FACING INSTALLATION WITH VEHICLE SEAT BELTS
Store LATCH belt by attaching to openings in
top of car seat. (see page 24 fig. m).
Hook connectors into storage openings
on each side of seat. (fig. a).
Adjust LATCH belt to remove excess
slack by adjustment belt.
Adjust car seat to upright position (see pages 18
and 19 Fig. c) and place forward-facing on vehicle
seat.
Thread vehicle seat belt through openings.
Buckle belt (fig. b).
Press down firmly in center of car seat to compress
vehicle seat cushion while tightening vehicle seat
belt.
Use your knee to press down in center of car seat
(fig. c).
1
2
3
4
LATCH belt MUST be stored when
using vehicle seat belt to install car
seat.
WARNING
Pull front to back and left to right to check for
secure installation (fig. d). Vehicle lap belt
MUST stay tight.
If not secure, see “Vehicle Seat Belts” page 25.
Attach tether strap hook (A) to anchor
hardware (B) and tighten strap to remove any
slack (fig. e). If vehicle does not have anchor
points to attach tether hook, tether hook
should be stored, see “Tether Storage”,
page 31.
Periodically check that car seat is securely
installed; adjust if necessary.
5
6